5HP Dust Gorilla Pro SMART Boost Cyclone Dust Collector
As low as $3,183.00
Compact, Configurable Design
The Dust Gorilla Pro can be equipped with your choice of Freestanding Leg Kit or Wall Mounting Bracket, built from heavy-gauge, powder coated steel for long lasting durability.
|Motor Type||U.S. Baldor® TEFC Motor|
|Motor Service Factor||1.15|
|Recommended Breaker Size||30A|
|Impeller Type||Single-piece, backward inclined, non-sparking/non-ferrous|
|Impeller Size||15" Dia.|
|Real CFM Rating||1,625 Actual CFM at 3" S.P.|
|Free Fan CFM Rating||3,250 CFM|
|Maximum Suction||23" WC|
|Noise Level||80-82 dBA @ 10 ft|
|Filter Media Type||G.E. H12 HEPA|
|Filtration Efficiency||99.97% @ 0.3 microns|
|MERV Rating||MERV 16 ±|
|Total Filtration Area||110 sq ft|
|Primary Build Materials||Cold Rolled Steel, SD Polyethylene|
|Static Resistance Rating||Conductive (Metal)|
|Contents||Blower Motor Assembly, Fan Housing, Cyclone Separator, Filter Plenum, FlameGuard Cartridge Filter, Internal Silencer, Remote Control, Hardware|
|Country of Manufacture||United States|
|Warranty Information||2 Year Limited Warranty|
|Certifications||Complete system is cETLus certified for indoor use|
|Applicable Patents||#8,491,685, #7,247,180, #8,496,719, #8,377,160|
|Inlet Size||7" Dia.|
|Outlet Size||Square ID: 7-3/8"(W) x 6-3/8"(H)|
|Discharge Size||9" Dia.|
|Height||94" w/ 35 Gal. Stand|
110" w/ 55 Gal. Stand
|Height to Center of Inlet||66.5" w/ 35 Gal. Stand|
78.5" w/ 55 Gal. Stand
If you have conditioned air in your shop, (Heat or cool) then exhausting outside can be costly. If your building is small and well-sealed, you can interfere with flue exhausts as well. Close neighbors might object. If the Dust Collection system is run intermittently it is generally not a problem. Most buildings have enough leaks and crevices where the aforementioned volume of air does not cause problems. If you have a problem opening or closing an outside door when the DC is running, crack a window slightly. The rule of thumb is for every 500 CFM have at least 1 sq/ft of return air coming back into the shop. A lot of our customers blow exhaust air outside successfully.
No. This system is designed for use collecting dry materials only.
Yes but you will need to install a Machine Adapter into the inlet first. These adapters are smaller on the raw end than traditional ducting so that they can slip into the ports on systems and tools i.e. a 5" Quick-Clamp Duct Machine Adapter will measure ~4.9" O.D. on the raw end.
Oneida Air Systems' dust collectors are designed and tested for wood and wood dust. They can and have been be used effectively for various other dusts and chips such as drywall dust, paper dust, agricultural dust, metal chips and other forms of debris. The customer is however, cautioned that some common materials when cut, ground or processed by machinery may become very dangerous: highly toxic, flammable, or deflagrable and explosive and they should therefore ensure that you use your particular use of a dust collection system in accordance to national, state, local, NFPA, OSHA and all other applicable codes.