Actual appearance may vary to that shown above.

6" Male Duct Adapter

Crimped on one end for easy flex hose connections. Raw end attaches over blast gate inlet.

These short sections of galvanized steel ducting are ideal for converting ductwork fittings (such as Aluminum Blast Gates and machine dust collection ports) to readily accept flex hose connections. Without an adapter, it can be quite difficult to secure flex hose onto raw (uncrimped) ports.

This adapter's uncrimped side will fit snugly onto 6" O.D. piping and should be held in place with machine screw or pop rivets. Oneida Air Systems recommends pre-drilling the holes before installation and using silicone caulk to ensure that the seal is air-tight.

Blast Gate Adapter Diagram
Ductwork TypeStandard
Connection TypeMale / Female
Crimp Depth1"
Primary Build MaterialsGalvanized Steel
Thickness24 Gauge
WeldingSpot Welded
Static Resistance RatingConductive (Metal)
Product Weight0.50
Country of ManufactureUnited States
Similar Products
Write Your Own Review
You're reviewing:6" Male Duct Adapter
Your Rating
Frequently Asked Questions
No Questions
Did you find what you were looking for?

Oneida Air Systems (OAS) is not responsible for typographical errors, omissions, or other clerical errors that may occur and makes every effort to provide the most detailed and accurate information available regarding our products. If you encounter incorrect information, please contact us. OAS reserves the right to restrict quantities and correct prices when necessary.